Floor Pads: Premiere Pads Blue Scrubbing Pad - Low-Speed Finishing Floor Machine Pads - Floor Machine Replacement Pads & Brushes - UnoClean

 

0

Blue Scrubbing Pad

$19.95
1 review

For scrubbing or heavy-duty spray cleaning. Removes soiled top layers of finish. Use with low speed autoscrubbers, floor burnishers, floor machines & Pad Drivers. View Brush Pad Reference List

Some sizes are special order only and may not be listed online, in the event that you need a size not listed, please call 1-224-654-6500 for a sales representative.

Premiere Pads High-Speed & Standard Floor Machine Pad Types:

Ultra High-Speed Floor Pad Types:

For use with floor machine speeds of 1000 to 3000+ RPM

  • Aqua Burnishing Pad - Ideal for high-frequency, high-gloss burnishing programs on softer floor finishes (Replaces beige pad).
  • Black Sanding Screen - Perfect for sanding dull and scuffed wood floors. Open-weave mesh design is nonloading and coated on both sides for reversible use - wet or dry.
  • Natural Hair Burnishing Pad - Natural hair and synthetic fiber pad works well on a wide variety of floor finishes and traffic conditions.
  • Natural Hair Extra Burnishing Pad - Greater percentage of natural hair and synthetic fiber pad designed for low-frequency burnishing programs on harder floor finishes.
  • Ultra Champagne Burnishing Pad - Designed for low to moderate burnishing programs on hard floor finishes.

Standard Floor Pad Types:

Do you want a brush or a pad driver?

If your preference is to have a dedicated product, select a brush. If you have a variety of applications, your choice may be a pad holder. The surface being cleaned and the amount of dirt build-up will help determine the selection. The key to remember when ordering these items is the block diameter in relationship to the machine size. A brush is sized 2 inches smaller than the machine because of the flare of the brush fibers. Pad drivers are specified 1 inch smaller than the machine.

There is an easy way to cross check your selection from the Floor Machine Brushes and Clutch Plates section of this web site.

  • A brush, long-trim pad driver, or short-trim pad driver without a riser, should be 2" smaller than the machine size.
  • A pad driver should be 1" smaller than the machine size.

Therefore, a 20" floor machine would use an:

  • 18" brush without a riser
  • or a 19" brush

This rule applies to over 90% of the applications.

Please Wait... processing