Never cause damage again with nails, strapping or tape!
Information about the EPA's New Renovation, Repair & Painting Regulations (RPP)
Use the Side Pack instead. It has everything you need to seal both sides of your ZipWall® barrier. It comes with 6 special 3' Foam Rail™ crossbars, 6 Side Clamp™ wall mounts, and a custom bag to carry everything. To seal the sides of the barrier, attach the Foam Rails to the Side Clamps, and then latch them to the poles next to the wall.
The Foam Rails will push the plastic against the wall, creating a tight seal. Overlapping them, enables you to completely seal any wall up to 9 feet high.
- Each Side Clamp™ wall mount is made of polycarbonate and is very tough. The Foam Rail™ cross bars included in this package are a special three foot size. The length of the rails in the Foam Rail™ 2pack are five feet.
- In some situations where you have large crown moldings and base board heat on the same wall the pole may be to far from the wall for the Side Clamp™ wall mounts to reach.
- Plastic Sheeting is not included, a wide variety of plastic sheeting & poly tarps are available seperately
- 6 Side Clamp wall mounts
- 6 special 3' Foam Rail wall mounts
- 1 Custom bag
EPA's New Renovation, Repair & Painting Regulations (RPP)
Are you prepared for the new requirements? Regulation compliance by contractors & firms for the renovation, repair and painting activities of target housing or child-occupied facilities built before 1978 for compensation takes effect April 22, 2010.
Lead dust must be contained by law, starting April 22, 2010
Sanding, cutting and demolition can create hazardous lead dust and chips by disturbing lead-based paint. Even tiny amounts of lead paint dust will poison children and adults. To protect against this risk, the EPA issued a rule requiring the use of lead-safe practices and other actions that will affect contractors. This was past into law on March 31, 2008.
Under the new rule, contractors that disturb 6 square feet or more of lead-based paint in homes, or child occupied facilities (built before 1978) must be certified in these new procedures and work practices before April 22, 2010.